Sliced Funky Tree


CD1095 sc98 sg704 crop

Products Used

  • CD-1095 Funky Tree
  • SC-98 Slime Time,
  • SG-704 Specta-Clear Peppermint

Decorating Accessories

  • CB-604 Soft Fan

Miscellaneous Accessories

  • Exacto Knife
  • multicolor bulbs (Hobby Hobby)
Designer: Elizabeth Carey


  1. Cast in a low fire body clay, while wet cut out slices of the tree as shown in the picture. Make a grove in the base to allow the cord to fit so the tree will stand flat. Clean with a wet brush to smooth the cutouts, remove the seamline while wet.

  2. Fire to 04.

  3. Thin SC-98 Slime Time with water so it is a pouring consistency, pour to the inside of the tree, make sure all the surface is covered, brush out the drips on the outside of the tree.

  4. Brush three coats of SC-98 Slime Time to the outside of the tree including the base with the fan brush

  5. Stir and shake SG-704 Peppermint well, brush one coat to the outside of the tree using the fan brush.

  6. Fire to 05/06.

  7. Bulbs were purchased at Hobby Lobby, wire to the tree on the back so they don’t fall to the bottom. Pier One sells clear bubble lights that would also look great in the tree