Bunny Pail

• Print

Details

Last Updated: Thursday, 16 March 2017 17:21

Designer: Pauline Rancourt

 

Instructions

1. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
2. Using the CB-604 #4 Soft Fan, apply 2 coats of FN-001 White to the outside of the piece, keeping off the handles and rim areas.
3. Cut out the rabbit and wet an area, and apply the paper cut out, pressing firmly to ensure there are no air pockets.
4. Use the Soft Fan to apply 2 blended coats of SC-1 Pink A Boo, SC-95 Pinkie Swear and SC-13 Grapel to the background.
5. Punch out of plain copy paper the 1" daisies.
6. Wet an area and press the daisies into place, making sure the paper is sealed to the ware so no color seeps under the flowers.
7. Using the Soft Fan, apply 2 to 3 coats of SC-7 Leapin Lizard to the background.
8. Remove all the paper pieces just as the color starts to lose its shine. If allowed to dry, the color will chip.
9. Using the CB-106 #6 Script Liner, apply 1 generous coat of SC-88 Tu Tu Tango to the flower centers.
10. Use the Script Liner to apply 3 coats of SC-95 Pinkie Swear to the inside of the ears and the nose.
11. Side load the Script Liner in SC-83 Tip Taupe and shade around the inside areas on the bunny's face and ears.
12. Use the Script Liner to apply 3 coats of SC-28 Blue Isle to the bow tie.
13. Using the same brush, side load in SC-32 Bluebeard and shade the edges of the bow tie. Then, using the CB-110 #10/0 Liner, add detail.
14. Use the Liner to outline and detail the entire piece with SC-15 Tuxedo.
15. Using both the Script Liner and the Soft Fan, apply 3 coats of SC-88 Tu Tu Tango to the inside, rims, bottom and handles of the can.
16. Stilt and fire to shelf cone 05/06.