Super Dad Wrench Mug
- Details
- Last Updated: Wednesday, 22 May 2019 15:38
Products Used
Bisque-
MB-1513 Handyman Mug - Wrench
- SC-6 Sunkissed
- SC-11 Blue Yonder
- SC-15 Tuxedo
- SC-74 Hot Tamale
- SG-402 White Designer Liner
- SG-403 Red Designer Liner
- SG-408 Orange Designer Liner
- SG-409 Bright Green Designer Liner
- SG-410 Bright Blue Designer Liner
- NT-CLR Clear Dipping Glaze or NT-BR Clear Brushing Glaze
- AC-230 Clay Carbon Paper
- AC-310 Silkscreen Medium
- DSS-0155 Comic Expressions
- RB-144 #4 Script Liner
- RB-106 #6 Script Liner
- RB-110 10/0 Detail Liner
- Sponge
- Water
- Palette & Palette Knife
- Scissors
- Permanent Marker
- Pattern: Download
- Pencil
Designer: Elizabeth Carey
Instructions
- Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
- Using the Soft Fan with SC-74 Hot Tamale, apply 3 coats to the inside of the mug. Allow glaze to dry between coats.
- Using the Soft Fan with SC-6 Sunkissed, apply 3 coats to the outside of the mug. Allow glaze to dry between coats.
- On the DSS-0155 Comic Expressions screen, locate the two empty quote bubbles, bomb and "OMG". Draw an outline around them in permanent marker. Cut them out with excess screen around the edges.
- Squeeze about 2 TBS of SC-15 Tuxedo onto the palette. Add a pinch of AC-310 Silkscreen Medium. Mix with a palette knife until it becomes the consistency of peanut butter. You may need to add more silkscreen medium or glaze.
- Place the screens on the mug one at a time. While holding the screen firmly in place, take a small amount of premixed silkscreen medium, and gently rub in circles starting in the center and working outward. Slowly pull up the screen to avoid smearing.
- Place the AC-230 Clay Carbon Paper over the quote bubbles. Place the pattern over the carbon paper and trace with the pencil.
- Use SG-403 Red to fill in "Super". Use the Detail Liner with SC-15 Tuxedo to outline the lettering. Use SG-402 White to make lines behind the lettering.
- Use SG-410 to fill in "Dad". Use the Detail Liner with SC-15 Tuxedo to outline the lettering. Use SG-408 Orange to go around the inside of the quote bubble.
- Use SG-408 Orange to fill in the flames on the bombs.
- Using the Detail Liner with SC-74 Hot Tamale, apply 1 coat to the "OMG".
- Use SG-409 Bright Green to make dots on the outside of the cup. They should be staggered and larger towards the top.
- Using the Script Liner with SC-11 Blue Yonder, apply 3 coats to the wrench. Allow glaze to dry between coats.
- Use SG-408 Orange and SG-410 Bright Blue on the wrench adjuster. Make dots going up the wrench using SG-409 Bright Green.
- Use the Detail Liner with SC-15 Tuxedo, to outline the details on the wrench.
- Using the Soft Fan, apply 1 coat of S-2101 Clear Brushing Glaze or dip into NT-BR Clear Dipping Glaze.
- Fire to cone 06.