Wild Roses Tray
- Details
- Last Updated: Monday, 11 May 2015 13:42
Bisque
- MB-1307 Handled Platter
- SC-1 Pink-A-Boo
- SC-14 Java Bean
- SC-24 Dandelion
- SC-26 Green Thumb
- SC-34 Down To Earth
- SC52 Toad-ily Green
- SC-63 Popeye's Favorite
- SC-89 Cutie Pie Coral
- SG-405 Brown Designer Liner
- FN-001 White
- FN-008 Brown
- CB-106 #6 Script Liner
- CB-110 #10/0 Liner
- CB-310 #10 Flat Shader
- CB-404 #4 Pointed Round
- CB-406 #6 Pointed Round
- CB-604 #4 Soft Fan
- BT-910 Synthetic Sponge
- AC-230 Clay Carbon Paper
- Designer: Bob Moreni
- Skill Level: Basic
- Time: 2½ hours
Instructions
- Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
- Using a CB-604 #4 Soft Fan, apply 2 coats of FN-001 White to the top surface of the platter. Allow to dry.
- With a pencil and AC-230 Clay Carbon Paper, trace on the pattern (just the outline not the detail). You will need to extend the pattern on the one side.
- Using a CB-406 #6 Pointed Round and a CB-404 #4 Pointed Round, apply 2-3 coats of SC-1 Pink-A-Boo to all flowers and buds. Allow to dry.
- If needed re-trace the just the flower pattern outline.
- Using a CB-310 #10 Flat Shader, shade all flower petals and buds with SC-89 Cutie Pie Coral.
- With the end of a brush handle, place a dot of SC-24 Dandelion in the small flower centers.
- Using a CB-406 #6 Pointed Round, apply 3 coats of SC-52 Toad-ily Green to all the leaves.
- Using a CB-310 Flat Shader, Shade the one side of the leaves with SC-26 Green Thumb and the other side with SC-63 Popeye’s Favorite.
- Using a CB-106 #6 Script Liner and a CB-110 #10/0 Liner apply 2 coats of SC-14 Java bean to all stems and branches. Apply a third coat with the brush loaded with SC-14 Java Bean and side load with SC-34 Down to Earth to shade the stems and branches.
- Using a CB-110 #10/0 Liner, outline and detail all flowers, buds and leaves with SG-405 Brown Designer Liner. Allow to dry.
- Using a CB-604 #4 Soft Fan, apply 1 coat of S-2101 Crystal Clear Brushing to the top of the platter. Allow to dry.
- Using a CB-604 #4 Soft Fan, apply 3 coats of FN-008 Brown to the back of the platter. Allow to dry.
- Stilt and fire to shelf cone 06/05.