Sea Foam Gnome Jar
- Details
- Last Updated: Monday, 18 November 2019 11:46
Products Used
Bisque- MB-1544 Gnome Jar
- CG-997 Sea Foam
- SC-2 Melon-Choly
- SC-9 Jaded
- SC-10 Teal Next Time
- SC-15 Tuxedo
- SC-16 Cotton Tail
- SC-20 Cashew Later
- SC-23 Jack O’ Lantern
- SC-88 Tu Tu Tango
- SC-99 Char-ming
Decorating Accessories
- RB-144 #4 Soft Fan
- RB-110 #10/0 Liner
- RB-106 #6 Script Liner
Miscellaneous Accessories
- Sponge
- Water
- Paper
- ½” or ¾” circle punch
- Scissors
- Dagger Brush
Instructions
-
Begin with properly fired shelf cone 04 Bisque. Moisten a clean sponge and wipe bisque to remove any dust.
-
Using the Soft Fan with CG-997 Sea Foam, apply 3 coats to the top of the hat. Allow glaze to dry between coats.
-
Using the Script Liner and Soft Fan with SC-10 Teal Next Time, apply 3 coats to the rim of the hat and inside the hat. Allow glaze to dry between coats.
-
Using the Script Liner with SC-16 Cotton Tail, apply 3 coats to the beard. Allow glaze to dry between coats.
-
Squeeze about 1 TBS of SC-99 Char-ming onto the palette. Thin with water. Use the Dagger Brush to float the thinned glaze over the beard.
-
Using the Script Liner with SC-20 Cashew Later, apply 3 coats to the nose and hands. Allow the glaze to dry between coats. Highlight with SC-2 Melon-Choly.
-
Using the Script Liner and Soft Fan with SC-23 Jack O’ Lantern, apply 3 coats to jacket and inside of the container. Shade with SC-88 Tu Tu Tango.
-
Use the circle punches to punch 10-20 circles in the paper. Cut them out with scissors to make a negative pattern. Dip each pattern in water and stick to the jacket. Using the Script Liner with SC-23 Jack O’ Lantern, apply 1 coat over each circle to make sure it sticks.
-
Using the Script Liner with SC-9 Jaded, apply 2 coats over each circle. Allow glaze to dry between coats. Remove the patterns before the glaze is completely dry.
-
Using the Detail Liner with SC-15 Tuxedo, outline the details on the container.
-
Fire to cone 06.