Dad's Stoneware Stein

 

Products Used

Bisque
  • SB-133 Stein 
Color
  • SW-001 Stoneware Clear
  • SW-144 Lava Rock
  • UG-31 Chocolate
  • SG-401 Black Designer Liner

Decorating Accessories

  • CB-604 #4 Soft Fan
  • DSS-106 #6 Script Liner
  • AC-310 Silkscreen Medium
  • ST-133 Woodgrain Stamp

Miscellaneous Accessories

  • Palette Knife
  • Sponge-on-a-Stick
dad stein
Designer: Carmen Allen
 

Instructions

  1. Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe the bisque to remove any dust.
  2. Using Sponge on a Stick load the sponge with UG-31 Chocolate making sure to tap off excess glaze. Too much color will result in a blurred, messy image. Apply the color to the ST-133 Woodgrain, while it is laying flat on the table. Turn the stamp over onto the desired area and press down; make sure not to rub back and forth or this will cause a double image. Repeat until the center section of the stein is covered in the stamp.
  3. Once the stamping has been completed, put some SG-401 Black Designer Liner out on a plate. Sprinkle some AC-310 Silkscreen Medium onto the glaze and mix with a palette knife until the mixture is about the consistency of peanut butter.
  4. Take the “Dad” screen from the DSS-130 Graceful Script set. Lay the screen flat onto the stein and rub the screening mixture through the screen. Remove the screen and wash immediately.
  5. Using a Soft Fan, apply 3 coats of SW-144 Lava Rock to the inside, handle, and rims of the stein.
  6. Apply 2 coats of SW-001 Stoneware Clear to the center section of the stein.
  7. Wipe any excess glaze off the bottom of the piece.
  8. Let dry completely.
  9. Fire to shelf cone 5/6.

Dad stein process

custom-css-security