Queen Anne's Lace

Details
Last Updated: Thursday, 09 November 2017 16:28

 

 
 
Products Used

Bisque
  • MB-889 8" Asian Flair Square Plate
Color
  • SC-45 Rawhide
  • SC-90 Elephant Ears
  • FN-001 White
  • S-2101 Crystal Clear Brushing
  • SG-402 White Designer Liner
  • SG-406 Brown Designer Liner
Decorating Accessories
  • CB-604 #4 Soft Fan
  • BT-910 Synthetic Sponge
Queen_Anns_Lace
 
 
Additional Materials
  • Pencil
  • Leaf Stencil
  • 2" Foam Roller
  • ½" Masking Tape
 
Project Info
  • Designer: Marcia Roullard
  • Skill Level: Basic
  • Time: 1½ hours
 

Instructions

  1. Begin with properly fired shelf cone 04 bisque.  Moisten a clean sponge and wipe bisque to remove any dust.
  2. Using a CB-604 #4 Soft Fan, apply 2 coats of FN-001 White to the top of the plate.
  3. With ½” Masking Tape, tape off ⅔rds of the plate to divide the plate.
  4. Using a CB-604 #4 Soft Fan, apply 2 coats of SC-90 Elephant Ears to the larger taped side of the plate. Allow to dry.
  5. With ½” Masking Tape, apply the tape over the SC-90 Elephant Ears section to block off that side
  6. Using a CB-604 #4 Soft Fan, apply 2 coats of SC-46 Rawhide on the remaining side.
  7. When partially dry or dry, lay on the leaf stencil, hold down with one hand then roll over the stencil with the 2” foam roller with SC-90 Elephant Ears darkened with some of the SG-406 Brown Designer Liner for the color to roll on.
  8. Sketch on the Queen Anne’s Lace design
  9. Using the SG-406 Brown Designer Liner for the design in the foreground.
  10. Use SG-402 White Designer Liner for the remainder of the Queen Anne’s Lace. Allow to dry.
  11. Using a CB-604 #4 Soft Fan, apply 1 coat of S-2101 Crystal Clear Brushing to the top of the plate.
  12. Using a CB-604 #4 Soft Fan, apply 3 coats of SC-90 Elephant Ears to the back of the plate. Allow to dry.
  13. Stilt and fire to shelf cone 05/06.

custom-css-security