Mistletoes Plate
- Details
- Last Updated: Wednesday, 09 October 2019 16:26
Products Used
Bisque- MB-103 Coupe Dinner Plate
- NT-BR Clear One Brushing
- SC-15 Tuxedo
- SC-36 Irish Luck
- SG-401 Black
- SG-403 Red
- SG-405 Green
- SG-704 Speckta-Clear Peppermint
Decorating Accessories
- AC-310 Silkscreen Medium
- DSS-0162 Holiday Icons
- AC-230 Clay Carbon Paper
- RB-144 #4 Soft Fan
- RB-106 #6 Script Liner
- RB-110 10/0 Detail Liner
- MC-002 12mm Low Tack Masking Tape
Decorating Accessories
- Sponge, water, palette, pencil, sponge on a stick, permanent marker, palette knife
- Baby's feet
- Pattern: Download
Instructions
-
Begin with properly fired cone 04 bisque. Moisten a sponge and wipe bisque to remove any dust.
-
Squeeze around 2 TBS of SC-36 Irish Luck onto the palette. Dip the sponge on a stick into the glaze and sponge one of the baby’s feet. Take the plate and press against the baby’s foot. Repeat with the other foot. Allow glaze to dry completely.
-
On the DSS-0162 Holiday Icons screen, locate the holly with 2 leaves. Draw an outline around it in permanent marker. Cut it out with excess screen around the edges.
-
Squeeze about 2 TBS of SC-15 Tuxedo onto the palette. Add a pinch of AC-310 Silkscreen Medium. Mix with a palette knife until it becomes the consistency of peanut butter. You may need to add more silkscreen medium or glaze.
-
Place the holly above the footprints. While holding it firmly in place, take a small amount of premixed silkscreen medium and gently rub in circles starting in the center and working outward.
-
Place the AC-230 Clay Carbon Paper onto the plate. Position the pattern so that the ribbons are next to the feet. Trace with a pencil. Position the pattern so that the lettering is below the footprints. Trace with a pencil.
-
Using the Script Liner and Detail Liner with SG-403 Red, apply 1 coat to the berries, ribbons, and writing.
-
Using the Script Liner with SG-405 Green, apply 1 coat to the leaves.
-
Using the pencil, sketch the name below “Mistletoes” and the year next to the prints.
-
Using the Detail Liner with SC-15 Tuxedo, make accent lines. Apply 1 coat over the name and year.
-
Using the Soft Fan with SG-704 Peppermint, apply 2 coats over the front and back of the plate.
-
Fire to cone 06