Black and Blue Striped Stoneware Plate
- Details
- Last Updated: Thursday, 18 April 2019 21:26
Products Used
Bisque- SB-105 12” Dinner Plate
- SW-115 Midnight Rain
- SW-140 Black Matte
- SW-170 Blue Hydrangea
Decorating Accessories
- CB-604 #4 Soft Fan
- CB-106 #6 Script Liner
- BT-910 Synthetic Sponge
Designer: Laura Fraedrich
Instructions
- Begin with properly fired shelf cone 04 bisque. Moisten a clean sponge and wipe bisque to remove any dust.
- Using the CB-604 Soft Fan Brush, apply 3 coats of SW140- Black Matte to the back side of the plate, leaving the bottom and foot unglazed.
- Using the CB-604 Soft Fan Brush, apply three coats of SW-140 Black Matte in 3 thick, irregular stripes, spaced out as shown in the photo. Add thin stripes in between the thick stripes so you have alternating thick and thin stripes.
- Using the Fan Brush, apply three coats of SW-115 Midnight Rain beginning at each thin stripe and moving to the right until you have covered about 1/3 of the next thick stripe. You will be overlapping the Black Matte with the Midnight Rain.
- Using the Fan Brush, apply three coats of SW-170 Blue Hydrangea beginning at each thin stripe and moving to the left until you have covered about 1/3 of the next thick stripe. You will be overlapping the Black Matte with the Blue Hydrangea. The center 1/3 of the thick stripes should just be the Black Matte without anything overlapping it.
- Wipe off any excess glaze from the foot of the plate with a damp sponge.
- Do not stilt or hang over the edge of the kiln shelf.
- Fire to cone 5/6.